Also,
after end failed the final data file contained 40,065 events
but when the screen froze it was only 33,800 !! So I got 7K
events from somewhere (clearly not the EB buffer)
hmm....
On Wed, 7 Aug 2002, Tancredi Botto wrote:
>
> I've apparently experienced another type of "hang". After
> so many evts (30K) Coda differential rate went to zero and
> the screen stop updating (that I believe I've not seen before)
>
> Waited a copuple of minutes but coda would not kick back in
> as it did earlier in the run during a "sleep". Rate was
> 100 Hz/25 and Kbytes/s
>
> Tried to pause, failed, end of run was not possible anymore (reset
> and re-started running). So I believe now that coda could really hang
> in the middle of a run (not just at the beginning)
>
> -tancredi
>
>
> WARN : blastROCr has not reported status for 337 seconds
> ERROR : blastROCr is in state disconnected should be active
> WARN : blastROC has not reported status for 1413 seconds
> ERROR : blastROC is in state disconnected should be active
> ERROR : Pause : TS subsystem(s) timeout !!!(45 45 1000)
> ERROR : TS : subsystem failed in activating state
> WARN : blastROC has not reported status for 1416 seconds
> WARN : blastROCr has not reported status for 340 seconds
> ERROR : ROC : subsystem failed in dormant state
> ERROR : EB : subsystem failed in active state
> ERROR : ER : subsystem failed in active state
> ERROR : Pause failed !!!
> INFO : blastER reset ......
> INFO : blastER reset ok
> INFO : blastEB reset ......
>
>
This archive was generated by hypermail 2.1.2 : Mon Feb 24 2014 - 14:07:28 EST