i have just finished adding the wire chambers' 6th-order distance-tot-ime
relations to the Monte Carlo. a few notes:
1) the 6th-order relations are now the default. thus if you update your
blastmc/ and Blast_Params/ directories and do absolutely nothing else,
the Monte Carlo will then be setup to use the 6th-order relations.
2) in general, to setup the Monte Carlo to use the 6th-order relations,
open your fort.99 file, go to the 'WTDC' command, and change that line
to the following:
WTDC 2.0 0.0 0.0
then run the Monte Carlo as usual. the full 6th-order distance-to-time
relations will be used.
3) in general, to setup the Monte Carlo to use the (old) linear relations,
open your fort.99 file, go to the 'WTDC' command, and change that line
to the following:
WTDC 1.0 1100.0 6400.0
then run the Monte Carlo as usual. the simple linear distance-to-time
relations will be used.
4) the reconstruction uses the 6th-order time-to-distance relations as its
current default. thus, you should use also the 6th-order
distance-to-time relations in your Monte Carlo runs.
let me know if you see any errors or anything suspicious-looking.
aaron
This archive was generated by hypermail 2.1.2 : Mon Feb 24 2014 - 14:07:30 EST